Search the Community
Showing results for tags 'test'.
Found 4 results
-
- 7 replies
-
- 4
-
-
- sand paper
- research
- (and 1 more)
-
-
This might be better in the "Tip" section, but.. How to check a square for...square? Get a nice straight edge piece of wood scrap. Set the square against that edge...and mark a line across the face of the board.. Yes, there are two lines there ( already done the test..) Next, flip the square over... Mark a second line beside the first one. You are looking to see IF the two lines are parallel to each other. If they are not? Square needs adjusted until it will pass this test. Usually a hammer strike on the blade..up or down..recheck, and adjust til it does pass. At least this old Stanley 8" passed the test...close enough for the girls I go with So..give it a try....doesn't take very long, either.
-
From the album: Gun Case
