Marking Jig for Chair Post
.thumb.jpg.573d1497d0675219908c85aabefd797a.jpg)
I sanded the post to 220, I did not get too carried away with the sanding on the rear posts, since it's going into the steamer, the grain will raise anyway. After I took the post to 220 I marked a couple lines where the rear and side rung holes must be drilled, and where the back slats will have to be mortised in by hand.
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.