May 21, 201412 yr Is getting a bit full, now made a run today for some barn Siding, and got about ten pieces. Also found a 2x10 x 24" pine board, a 3x3 x 24" Spalted something or other, and Someone asked about a 2x4 x8' made from Oak? Got one today, only I think it is Red oak. Photos after the thunderstorms go away Brought home most of the small tools out at the old Pole Barn Shop. Cleaned off the Table saw to get it ready for Craigslist. Found out that old rip blade in the saw is still VERY SHARP! A-yup, that blade. Was running a belt sander around to clean off the rust, got a cut on the forearm. Wiping the top down after the clean up, palm of the right hand, near the wrist, found two teeth on the blade. Now have two holes there, as well. Now, about that 2x4 in Red Oak........
May 22, 201412 yr Author May have to cut that one down a bit? Thinking about a Chinese style jointer plane, or a jack plane? That would get it down to....seven feet...
May 22, 201412 yr Yea that could work, then you'd only have to back off maybe 5 ft to get all 7 ft in the viewfinder LOL.
May 22, 201412 yr Author Got the nine footer cut down a bit, shortest is still 2' long Ah-yup.A close up of these Supposed to be red oak. There is a special board I forgot to tell about Green spalted ?? 2-3/4" by 2-3/4" by 22" long. I'd say square, but it ain't square, yet. Stanley #5-1/2 will see to that. Green Spalted?
May 22, 201412 yr Pretty good looking wood Steve. I have done just what you have done with that blade, seems like sometimes you just gotta get near it and you get cut!
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.