Winners have been randomly selected, please see the list of lucky recipients at Winners Announcement. Please scroll down a tad at the original topic to view the list.
Search the Community
Showing results for tags 'repurposing'.
Found 1 result
As I stated in my PC build located in the link below I'll be building a Desk/Cabinet for the PC. I'll be repurposing a "White Clad" Ice Box type end table/night stand like the one below as the base for this Desk/Cabinet. The photo is of one listed on ebay, I have to go down to my storage tomorrow and get the one I have. It is in a bit rougher shape than the one in this photo. I'll be doing this up similar to a Secretary Desk with an upper section that will house the monitor. I'll be using parts from one of those Oak Toilet Toppers along with other bits and pieces along the way. I don't work from any plans, simply just wing it, and figure this will look good here, that will look good there etc. I've also got some real neat cast Brass Brackets that will get incorporated into this build. I've been working on what will be the top (Monitor) door along with the PC build to get this started. Here are a couple of photos of the door before I got started on it. It is the worst shape piece of this build, but it came from a junked "White Clad" cart, and matches the door on the "Ice Box" These are some really cheaply built doors in that the frames are simply attached to a 1/8" plywood back which also serves as the door panels. The veneer on this door is in real poor shape, but the plywood is still rather solid. Below are a few photos of the door as work progresses on it. This is an edge photo of the door you might be able to make out the plywood back. The frame members on these doors are not spliced together in any way, and I added braces to the rear side of the door to keep it stiff, and straight. the edges kept wanting to bend away from being straight with the other frame members. The door is looking much better then when I started with it. Almost half of the veneer has flaked away, and I'm not sure if I'll re veneer it, or cover it with some Plexiglass Mirror that I have. That's about it for today on this build. Until next time.