Search the Community
Showing results for tags 'burned'.
Found 3 results
-
I made this ring to be used as a frame. I'm wondering about burning a trim mark or two around the circumference, similar to using a wire to burn a mark on a spindle. Is it even possible? My plan would be to leave it in the cole jaws and use a nail or something rested on the tool rest, holding it against the ring as it turns. Since this is in those jaws I may not be able to run it fast enough to burn, and my plan of using a nail with the end ground round might not work....or would it? At this point I'm still experimenting/learning what's possible.
- 15 replies
-
- 5
-
-
- question
- embellishment
- (and 2 more)
-
I did a smaller version of this a while back, don't remember if I posted pictures or not. Anyway, this bowl is just over 12" diameter. LOTS of time invested and to be invested in this one. I really enjoy it though, the glass of wine and the view from the patio don't hurt either. This is done in layers at different heat settings. The first layer is done all around and most of the second as well. It will probably get at least two more layers at increased temperature before I do the rim pattern and finish the bottom. Steve
-
Challenge Coin Flag
Robert McMillan posted a gallery image in Small Crafts, Boxes, Picture Frames, and Lighting
From the album: Laser Engraver Pieces
