Help with FoxAlien Masuter Pro

[KevTN]

How did it go? Almost sounds like EMI, Electrical Mechanical Interferance. 

[Grandpadave52]

On 8/16/2023 at 1:43 AM, longship said:

I just had this same problem cutting a few circles for a friend.  It was proceeding along just fine along the profile and about halfway down it jetted straight left. I thought it was something with the wood because it happened three times in the same area, about 8 o'clock on the circle.

 

I was tracking it with a vacuum and I read the prior comments indicating that could be the issue.  I'll try again tomorrow and will refrain from vacuuming to see if that has an impact at all.  If anyone has any other ideas on what may cause this I'd appreciate the help.

 

Longship

Masuter Pro

Bauer Router

Sorry so late seeing this. I have no experience in this arena but perhaps @4DThinker, @honesttjohnor @difalkner might see this and offer some insights in addition to @KevTN. Any feedback on what you found would be appreciated. Again, apologies for not seeing your post previously.

 

BTW, welcome to The Patriot Woodworker. 

[difalkner]

Already chimed in a couple of times, Dave.