Search the Community
Showing results for tags 'rails'.
Found 1 result
-
Well, there is all the parts Frame & Panel parts. Just finished milling the last leg parts.Had some nasty stuff to cut away, though Just to make two back leg blanks for the end panels. Cleaned up some rails Set up a three screw jig to remove the "cope" from the tenon. Used a #3 handplane to "Chute" away the lip, and mill the shoulder back to square. Third screw is behind this rail. Most of the old parts had a two layer "veneer" , some even had a thick paper as the outer layer. Pried most of it off, to get down to the "real wood" underneath the glue. Milled a few last grooves, and will start to mill tenons tomorrow, I hope. Even tried a test fit Ok, so I still have some work to do on this.... Raised panels have been sitting around, awaiting to be installed in the frames. Trying to build this chest with just the parts scrounged from the old bed frame. Might even have enough left over, to glue up a fancy lid... Stay tuned...
