Search the Community
Showing results for tags 'burnish'.
Found 2 results
-
To get a nice sheen on a turning after sanding thru the higher grits, grab a handful of shavings, dial up the lathe RPM's and hold the shavings against the spinning piece.
-
I was watching a video of a guy turning a pepper mill and he was sanding the turned piece. Then he did something I've never seen before. He grabbed some of his wood waste shavings and held it against his turning piece. He had already sanded it down to a very fine finish. I can't see this as being any more effective than very fine sandpaper or 0000 steel wool. I will try it................Do you use this technique?
