Search the Community
Showing results for tags 'scrolled'.
Found 3 results
-
Below is a star shaped bowl made entirely with the scroll saw, The woods used are sapelle and baltic birch plywood. The bowl consists alternating layers of sapelle and baltic birch plywood. There is just one ring that was cut and then glued on to the base. The bowl is just 4 inches in diameter and about 2 inches high. After sanding to 220 grit the bowl was sealed with a 75 / 25 pure tung oil and mineral spirit mix. After the mix set it was then sanded to 400 and a top coat of shellac was applied. Very easy to make. DW
- 9 replies
-
- 2
-
-
- sapelle
- baltic birch
- (and 2 more)
-
Designed by Keith Fenton at Sheila Landry Designs. The intersecting word is cut from 1/8" maple that I stack cut 3 at a time. Then I mount onto 1/2" stained backer board made out of pine. The brass pins in the corners are for decorative purposes only. Then I top coat with a stain spray and attach saw tooth hangers on the back.© Keith Fenton from Sheila Landry Designs
- 1 comment
-
- 1
-
-
- scrolled
- intersecting
- (and 1 more)
-
Custom designed by Keith Fenton at Sheila Landry Designs. The intersecting word is cut from 1/8" maple that I stack cut 3 at a time. Then I mount onto 1/2" stained backer board made out of pine. The brass pins in the corners are for decorative purposes only. Then I top coat with a stain spray and attach saw tooth hangers on the back.© Keith Fenton at Sheila Landry Designs
