Search the Community
Showing results for tags 'necessary'.
Found 2 results
-
I'm still playing with the 2 part, 30 minute epoxy. I have refined my set up and application process. I am still learning. Here are some rules I use a low RPM manual setup to regulate RPM 1. MOST IMPORTANT! Clean your lathe and surrounding area of all dust. Just one little mistake will show up and stay. 2 Apply slowly with a small brush while turning at slow RPM 3. Go over any areas that look like they need it. Remember that curing time can creep up on you. 4. Once you are satisfied, allow the piece to continue turning for 45 minutes (curing time is 30 minutes on the epoxy I used) 5. Shut down and allow it stand in the lathe for 24 hours for a full cure. It does look like glass. NOT everyone likes Christmas ornaments that look like that. I do.
-
