Search the Community
Showing results for tags 'combination blade'.
Found 1 result
-
I have been using a Woodworker II for quite a few years and it has served me well. Well almost. I returned it to the factory for sharpening and they blew it. I sent it back and they did it again. Each time they left silver solder bubbles on the teeth they replaced. The saw blade has never been the same. Any way my subject is; If you was going to buy a good 10" combination table saw blade, what would it be? Would it be thin or thick cerf? I'd like to get it for a reasonable price too. I paid $120 for the old one and I would like to get a nice one for a lot less. Since sharpening is costly and may not come back sharpened properly I'd rather just buy a new on Your thoughts are appreciated
