Search the Community
Showing results for tags 'cleat'.
Found 1 result
-
Got the second front/back panel in and out of the clamps. Added the mending plates at the top, and a cleat for the floor along the bottom. Then just stood it upYep, going to be wee bit bigger than the first one. Then Spent most of today getting some parts made up for the two ends Just imagine two of each of these. And I got the router fixed up to route some more grooves, First one was burned.....Hmmmm, checked the speed setting? Ah, clear down in 3rd gear...moved it up into 6th gear and try again. Much better. Ran a few planes around, to get all these parts to match up. Trimmed a few ends square. Awaiting the bench to be cleared off, before the chopping of mortises begins, again. Cleared off the bench? Weellll I have a blank in the clamps right now.. Ok, so the plan to recycle the old raised panels from the bed frame didn't work out. Needed to make new, larger panels. This is actually two panels, just need to cut them out of this big blank. One board in it needed a little joiner work In this shop, that IS a little joiner. Added a couple 1x3 of barn wood, one on each edge, abd glue it up. Now I just sit back, and watch glue dry.....I'm bushed.
