A little work in the shop. Work nights, so this is MY day time. Almost lunch time!

Anyway, have been trying to get a bottom panel made for a full blind dovetailed box. Ran some grooves with a plough plane, that Might even be older than me

 

Fancy set-up, I guess. Just for a few 1/4' by 1/4" grooves. been using a rebate plane along the edges of a piece of pine scrap. I was hoping to make a bottom panel out of it. The wards 78 wasn't too bad doing that, but the panel was way out of square. Ran over, and picked up a couple more items for the bench top. A homemade shooting board, and a Sargent #414c Jack plane.

 

 

Laid one edge against that Oak stop, and shot the end grain. Rotate towards the freshly shot edge, and shoot another, repeat until all four edges were done. This kind of threw the rebates off a bit, so I had to go back over all of them. I also ran a smoother over the face grain of the panel

 

 

Just hate it when a board is too smooth, and shiny.The glare is worse than the top of my head. Got things about ready for a test fit

 

 

Hmmm, GRRRR! Back to the shooter jig. That big, ole knot was causing a problem. Narrowed the board a bit. Try this a second time

 

 

well, at least there is SOME progress going on. At this rate, I MIGHT, just might be fitting a lid to this box in.....June?

 

Might have a shot of the rebates, somewhere.

 

 

Man, the glare off that.......board, yeah, off the board. Remind me to start wearing a hat outside....

Awesome post! Have you ever tried a Router Plane?

Nope, not yet. Have seen a couple in the wild around here, though.

Fine job there Steve, thanks for sharing your neanderthal shop and work with us once again.

Hey, next time would you consider shooting the board to square first before the rebates?

 

 

Very Nice Steve, Thanks for the post.