October 15Oct 15 comment_381885 11 minutes ago, Rusty S said:any ideas on preventing this,I can only speak from my experience with doing rolling pins and gluing the inserts into slots. Using about 3 times as much glue as you think it might take. Every surface gets a HEAVY dose of glue- including the bottom of the slot. Brushed out and inspected for coverage. Report
October 15Oct 15 Author comment_381897 Good advice but my slots are only .125 wide, need a real narrow brush 🤣 Report
October 15Oct 15 comment_381898 47 minutes ago, Rusty S said:Good advice but my slots are only .125 wide, need a real narrow brush 🤣Maybe something shaped like a popsicle stick but thinner Report
October 17Oct 17 Author comment_381973 Well repair to inside of went well And even smoothed out pretty well But then i turned it around and tried to finish the bottom and here we go again Hope when the glue dries it will finish up nicely. Cross your fingers. Report
October 18Oct 18 Author comment_381992 got lucky and found the missing pieces in the shavings pile. Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.