September 5, 20178 yr comment_123554 So how did this get made without any tear outs and boo boo's. Report
September 5, 20178 yr comment_123557 Don't know how but this is who- http://www.delmano.com/PastExhibitions/Weissflog2012/hansweissflog4.html A little more- http://www.carolinamountainwoodturners.org/articles/92 Edited September 5, 20178 yr by lew Report
September 5, 20178 yr comment_123571 Looks like a two axis piece. Could have been turned as a big ball and then split in half and remounted to turn the inside of the bowl. Might be two of them out there. Report
September 7, 20178 yr comment_123738 Have looked at this several times and think I know how. Has to be done by starting between centers to turn a large ball. Then turn the concentric lines on the entire ball and 2 rings (rings because they will look like Saturn rings). Cut this (or part) into two halves (this could make 2 bowls). Then hollow and turn inside rings. The problem I cannot figure is how to turn the inside , that is how to mount it. Thinking maybe on faceplate with the screws going between outer rings, then the inside turned till get to screws tehn inside done by power carving. Any ideas? Report
September 7, 20178 yr comment_123753 Found these links unfortunately the author describes his process without the aid of pictures http://www.woodworkforums.com/f8/weissflog-ball-box-video-167895 http://www.woodworkforums.com/f234/ttits-shot-102450 Report
September 7, 20178 yr comment_123797 11 hours ago, lew said: Found these links unfortunately the author describes his process without the aid of pictures http://www.woodworkforums.com/f8/weissflog-ball-box-video-167895 http://www.woodworkforums.com/f234/ttits-shot-102450 I think that is above my paygrade Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.