October 16, 20169 yr comment_79317 While these would be nice to use..... I don't think they would work too well with these kind of bits.. The mallet is there just for Lew to look over, again... Anyway, I need to drill a few holes with the larger of these bits. Then run that 16" #11 to house the square ends. Sooo.... L-R: 14" or a 12", or a 10"...or a 8", or a 6"? I think the 6" might be a bit too small? Might use the larger ones. BTW: had to re-flatten the end of the bench...getting a bit worn.... Report
October 17, 20169 yr comment_79462 Very nice Steve. I like seeing them rust free like yours are. Shows they have been used and well cared for. Report
October 17, 20169 yr comment_79469 Those are sweet. Looks like the bits are pretty clean, too. The larger sweep will give you more leverage, so i would just use the largest one comfortable to use in the space available. Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.