Search the Community
Showing results for tags 'splines'.
Found 2 results
-
Woke me up from a sound sleep...first good night's sleep in quite a while, too but....Single Brain Cell Sketch Up had come up with an idea...and would not let it ( or ME) rest. Idea is to take a few 1 x 4 x whatever Ash boards and make a Jewelry Box with beaded, mitered corners...hmmm...Cut the sides to about the right size.....add a groove to the end grain ends.. haven't cut anything, just yet......as for the miters? Each end gets 2 miter cuts. Figure I can tilt the tablesaw to 45 degrees, and run each end through to make both cuts..in theory Because two ends will fit like this... Not much space for glue? Until I add a beaded spline.... Bead via the Stanley 45, then a few cuts so this thing will fit into the grooves... I'd form up the bead first....then saw cuts to remove the waste....one cut to clean off from the bead...then a couple cuts to free the piece up... May carry that mitered edge all the way around....may even do the lid to match, maybe...bottom will get housed into a groove...like the bottom of a drawer. And, this is what woke me up? Have things drawn up on paper, have to hope Boris doesn't steal the Plan... Stay tuned...
-
I sure was impressed with this video. Looks useful to me.
