Search the Community
Showing results for tags 'direction'.
Found 1 result
-
I had another piece of this stuff so I thought I may try to play with it. What I don't know is whether that's possible...especially after I trimmed it down a little, maybe i screwed the pooch with my trimming. Anyway, the first 2 photos show the front/back if you will of what i started with. Thinking I needed a flat surface on one side, I slabbed some off to give me just that. Then I cut a little off one end to "square" it up a little. So that's what I have left. I was thinking about a small platter or shallow bowl showing the crotch of the branch coming off of it. The piece I have left is about 6 1/2" tall (long grain) and about 8 1/2" across at the branch stub. Without any direction at this point I might try to put a worm screw into the flat part centered across the 8 1/2" dimension and try to round it out some and put a mortise in the other side to accept chuck jaws. But maybe i should just put this on my brush pile to burn. Advice?
