Search the Community
Showing results for tags 'curved'.
Found 1 result
-
Sooo, bought some Red Oak, and needed a project idea... Three planks, at $22.98 each ( OUCH!) 1/2" x 5-1/2" x 48"... Grain details, of the top board...other 2 are a little more plain....so, watch a series of videos by Paul Sellers' Masterclass. Downloaded the plan for a Keepsake Box with curved sides So, I'll give him the credit for the design. I'll have a few small details that will be a bit different. Cutting list as provided.. Where he used 9/16" thick stock...I'll have to use 1/2" thick stuff.....I'll have to see about that 5/8" thick stock... So, here we go.."Start up" phase....details? Curved corner details....looks like fun? Applied feet (to make)Lid gets sawn free of the box, note the cut line. Bottom and the panel for the lid are to look like they are floating, but.. They sit in a narrow groove..3/16" at that...we'll see how that works in 1/2" thick stock....he uses a plough plane even on the end grain. He also cuts a stopped dado for that divider to sit in. There is a carved, curved finger grip for me to gouge out(up) Had a pair of Hinges I thought about using.... Maybe....would be surface mounted, and inlaid flush with the surface....we'll see.. Need to haul the Plans and the Planks to the shop. The Masterclaases are Free, just log onto Paul's site....He also has a pay per view Masterclass....but, since I am a bit on the Frugal side (NOT cheap) I went with the Free site. Might be worth checking out...? Boss has errands to run, whenever the "Fliver" gets warmed up (16 sunny degrees outside, about 50 degrees too cold for me) Stay tuned....this might involve a small bit of cussing.. (ya think?)
- 61 replies
-
- 12
-
-
