11 hours ago, lew said:

close- it's a kilogyromaster  stosterses  frampauls with  subdirlesguse  lonication

 Is this one of those deals where the outside diameter needs to be larger than the inside diameter to keep it from falling inside?

1 hour ago, DuckSoup said:

 Is this one of those deals where the outside diameter needs to be larger than the inside diameter to keep it from falling inside?

 

 ... Or is it one of those deals where the outside diameter is smaller than the inside diameter so it keeps the inside diameter from collapsing?  ... 

I've found it indispensable for turning these-

 

I've thought about adding rollers to my factory made steady rest for my 11" lathe like this.

Doubt that those cool flasher wheels would fit though. 

That goes on a metal lathe so you might turn some small round round metal wheels that would work .Don't think any skate wheels could shrink small enough to use!

1 hour ago, Larry Buskirk said:

Doubt that those cool flasher wheels would fit though. 

 

13 minutes ago, Smallpatch said:

That goes on a metal lathe so you might turn some small round round metal wheels that would work .Don't think any skate wheels could shrink small enough to use!

 

Remove the bearings from the wheels and use them.

4 hours ago, Smallpatch said:

That goes on a metal lathe so you might turn some small round round metal wheels that would work .Don't think any skate wheels could shrink small enough to use!

 

Actually made for the 1930's Delta 11" Lathe that had attachments for light metal work.

 

I kind of figured the skate wheels were too big. Delta did on a later version for the 12" lathe use small bearings on the arms.