Popular Post RustyFN Posted January 20, 2021 Popular Post Report Posted January 20, 2021 I made a jig to cut my blank round before I put it on the lathe. Gerald, Cal, JimM and 5 others 8 Quote
lew Posted January 20, 2021 Report Posted January 20, 2021 Nice! Is the hole the size needed to thread in the worm screw? Cal and FlGatorwood 2 Quote
RustyFN Posted January 20, 2021 Author Report Posted January 20, 2021 I don’t know. I never use a worm screw. It is a 3/8” hole. lew, p_toad, FlGatorwood and 1 other 4 Quote
Steve Krumanaker Posted January 21, 2021 Report Posted January 21, 2021 Did you just clamp the board in place? Looks like it worked really well. FlGatorwood and Cal 2 Quote
RustyFN Posted January 21, 2021 Author Report Posted January 21, 2021 Yes it is clamped to the bandsaw table. I can adjust it to cut any diameter. FlGatorwood, Cal and Steve Krumanaker 3 Quote
Gerald Posted January 21, 2021 Report Posted January 21, 2021 That turned out to be a good idea. Cal and FlGatorwood 2 Quote
HandyDan Posted January 21, 2021 Report Posted January 21, 2021 That will trim some time from your turnings. Works well. Cal, RustyFN and FlGatorwood 2 1 Quote
FlGatorwood Posted January 22, 2021 Report Posted January 22, 2021 I like the simplicity of it. I have one that I made that attaches to the table and you can slide the arm in and out to get the desired diameter. p_toad, RustyFN and Cal 2 1 Quote
Popular Post RustyFN Posted January 27, 2021 Author Popular Post Report Posted January 27, 2021 I have had a lot of questions on how it is attached to the table. A bar clamp on each end. The clamp on the outside keeps getting in the way so I redesigned it. The new jig lets me get both clamps out of the way. DuckSoup, p_toad, Gerald and 2 others 5 Quote
RustyFN Posted January 28, 2021 Author Report Posted January 28, 2021 Here it is with clamps. DuckSoup, Gerald and p_toad 3 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.