Well folks been away for a while. Long story short. Got laid off my job. Went to Texas as part of the FEMA relief working the COVID ICUs for two months. Found a new job. I hope to get back to some wood working soon. Got a new Rikon 6 inch jointer I need to build a stand for. 
 

Anyways here is the finished product I was working on before I left for Texas...As always I am open for any suggestions for improvement.

 

 

Good to hear you are well despite circumstances.

Good to see you back, Kev. 

Glad you are back working and good to have you back posting.

Hoping things are getting better for you, good to see ya back here.

Hey, Good to see you back! That bat display turned out wonderfully!

Glad to see you back Kevin.  Is your new job in Texas?

With all this covid mess all over the country it's hard to wrap my head around any health care workers being laid off - but I do know it is happening.  Best of luck to you with the new job.

Edited October 11, 20205 yr by Cal

On 10/11/2020 at 8:01 AM, Cal said:

Glad to see you back Kevin.  Is your new job in Texas?

With all this covid mess all over the country it's hard to wrap my head around any health care workers being laid off - but I do know it is happening.  Best of luck to you with the new job.

Thank you...No sir I am still in TN. I travel the country supporting monitoring equipment. I was in Tx as part of the FEMA relief. A lot of healthcare workers took big hits. I would love to say how the media and the CDC has completely botched this whole thing but it is was it is.   I appreciate the well wishes.