February 5, 20188 yr Popular Post comment_139574 On another site, there was a thread about wanting to use a #8 Jointer plane....in making boxes and trays... I made up a little show & tell.....the OP has a #62 ( I think) and was wanting to buy a #8. A #5 Jack plane is roughly the same size as a #62, so.. In my case, this would be the Millers Falls #14 Jack plane sitting beside my Stanley #8.....bit of a size difference? Jack has a 2" wide iron, the #8 has a 2-5/8" wide cutter...Hmmm, maybe if we try a Jumbo Jack instead? An inch or so longer, and the cutter is a 2-3/8" wide....rather an "overweight" Jack plane? So, what would be a little easier to use than the #8? Couple of inches shorter...about a pound or so lighter, and has a 2-3/8" wide cutter..Stanley No. 7c, Type 9 See a difference? Which would YOU want to push around all day long? Well, there IS a shorter version out there.. Stanley called it a small jointer, a Stanley No.6c, type 10....about 6" shorter than the #8, and has a 2-3/8" wide iron... All three are indeed "Jointers" Which would you want to push around all day long....Me..I'd rather push the "Spare Tire" around.. 2 patent date, low knob Stanley #4.....tape is for a better grip. Sweaty hands, after a LONG day, I need the grip. That concludes the Show & Tell, for today...any questions? Report
February 5, 20188 yr comment_139601 just curious if you find the very close placement of the handle hard on your hands (i.e., not enough room)..?? Report
February 6, 20188 yr comment_139618 Steve, I never took pilot's training so I'd be a poor pilot to fly those planes. BUT !!! I'd sure like to try ! That is quite a collection Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.