October 2, 20178 yr comment_126741 In the middle of digging the router table out of it's hide-out....something came out as well... Just three pieces of scrap, glued and screwed together.....into a rip/crosscut jig.....or fence. Long ago, I made this little jig, to replace the cheapo fence on a DeWalt Job Site saw...You can barely see a cleat under the near end...it was sized to ride on the fence's rail. Couple of c clamps to attach to the rail. Have since used this as a saw guide for crosscuts with the circular saw. Also can guide a router for doing dados. Might just set it up as a rip fence for the bandsaw.. Something like this? Figures, now that all the rip cuts are done, this jig shows up.... May do a story about how this was made.....as the story in the old WOOD forum is long gone... Report
October 2, 20178 yr comment_126744 If you would have been looking for that fence, probably never would have found it! Report
October 2, 20178 yr comment_126805 That's the way it's supposed to work...finding it after the need is over. At least that's what I've always assumed, since that's what always happens. Report
October 3, 20178 yr comment_126872 I hate when that happens... Paint it orange or yellow so it'll be easier to hide next time Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.