Good Morning Friends,

Well here is today's quiz; How can one achieve six profiles with one router bit?

up & down and the fence

17profiles_3bits.pdf

What Stick said

 

And, you can adjust the bit height (up or down) to use only part of a profile, use a smaller or larger bearing

Add a wedge/ramp to angle how the wood meets the bit.  Use the TALL fence to run the face of a board past the bit.

 

Or....just get a Stanley #45 and change cutters as needed....like I do.

Or, read the article in issue 240, July 2016 of WOOD magazine: 6 Profiles from One Router Bit

Edited December 3, 20169 yr by Chips N Dust

2 hours ago, Stick486 said:

17profiles_3bits.pdf

Sure you can't squeeze another out ,you are one short.

Herb

2 hours ago, Dadio said:

Sure you can't squeeze another out ,you are one short.

Herb

sure I can...

Hello All,

Chips and Dust gave the correct answer as  his answer was exactly where this quiz came from and  Jim Heavey made it simple.

10 minutes ago, Ralph Allen Jones said:

Hello All,

Chips and Dust gave the correct answer as  his answer was exactly where this quiz came from and  Jim Heavey made it simple.

Way to go Chips!!!!

And thanks so much @Ralph Allen Jones for the quizzes, enjoying everyone of them!