Jump to content
  • entries
    3
  • comments
    34
  • views
    1,369

About this blog

Basic knowledge on dust collectors and the set up of dust collectors. Only from My experience and knowledgefrom posts of others. Disclamer: I am neither an engineer nor professional on Dust Collection. Many options exist which are beyond thescope of this blog although I may mention some of them in passing.

Shop_Tools_and_Machinery_at_Grizzly.com_-_2019-09-01_21_00_13.png.77fb8f27c855d0ac53fd9b80de3cefdc.png

Entries in this blog

Ducts and blast gates

Now this may be getting the cart before the horse but lets call it collecting supplies you will need to connect your DC to machines. Thin wall PVC will work just fine . For the best you can order metal ducts any size you want but you will also have to buy expensive connections .   A consideration many people talk about is grounding the dust collector and duct. To my knowledge and every forum I have been on and every article and book "there has never been a explosion in a home workshop

Gerald

Gerald

What my current setup is

Thought it might be best to start off with what my current setup is or at least parts of it. My Dust collector  is a Grizzly 1029 2 hp operating on 220v. It had a 5 micron bag top and bottom when purchased and was upgraded to a canister filter from Penn State. My collector is located in the attic of my shop in a insulated enclosure and a 12x24 filtered return to the shop. Power is controlled with a Long RAnger remote.    Ducting I used is 4 inch thinwall PVC. We will get into ducting a

Gerald

Gerald

Make your own blast gates and add ons

Ok finally got a little time to continue. First lets talk about blast gates and routing boxes. I made these from plans in either Wood magazine or Shop Notes but did not write the issue on it. This gate is for individual tools or can be mounted in the duct . Basically this one is ply for sides and 1/8 masonite scrap for the blade. The plastic PVC connector is a piece of thinwall with about 1/2 inch cut out and then use PVC glue. This will allow the 4 inch flex to be attached.This could

Gerald

Gerald

×
×
  • Create New...