September 12, 201312 yr comment_9191 Built a DP table for my Shorty Shopsmith. The plans were in Woodsmith.  Had to modify them slightly to work on the shopsmith. First pic is the table ready for use. The second shows the mods. The Woodsmith plans show bolts in T nuts to hold it in place on a regular DP. I just milled a piece to slip into the miter slot and added pieces on each end of the ‘Smith’s table. If you could see the holes in the other Smith’s table, you'd know why I had to build this aux, table. (Insert embarrassed Smiley icon) Other than the hardware and hard board, the rest was scraps. Gene 'The true soldier fights not because he hates what is in front of him, but because he loves what is behind him.' G. K. Chesterton Report
September 12, 201312 yr comment_9193 Nice. I prefer using capturing/alignment management to bolts. Much quicker to make changes. Lew Kauffman-Wood Turners Forum HostTime Traveler and Purveyor of the Universe's Finest Custom Rolling Pins! Report
September 13, 201312 yr Author comment_9192 Me too, Lew. In this case, I had no real choice. Gene'The true soldier fights not because he hates what is in front of him, but because he loves what is behind him.' G. K. Chesterton Report
Archived
This topic is now archived and is closed to further replies.