24 minutes ago24 min comment_382921 What's it for? Cleaning rusty metal parts.You can buy them but most are expensive IMO.So I jerry-rigged one.I used an old Craftsman random orbital sander and double sided carpet taped a dollar store stainless bowl on the sander's pad.Then I turned the switch on. At this point it hasn't been plugged into wall yet.Next I set it all into a HD 5 gallon plastic bucket.Next I filled the bowl with 3 - 4 cups of kitty litter. I find it works best.Then I threw in a few really bad rusty nailsI placed a towel over the bucket to minimize noise but let it vent some for any trapped heat exhaust from sander.I plugged it into the outlet and only ran it for 3 minutes.Here's what the rusty nails looked like when pulled out.Cleaned up pretty good for only a few minutes. 5 - 10 minutes would have polished them.Here's some handplane parts that were rusty beyond belief on the old Stanley Defiance plane that I'm refurbishing. I ran them 9 -10 minutes.Pretty neat.. right?Thanks for looking!Cheers!MrRick Edited 20 minutes ago20 min by MrRick Report
11 minutes ago11 min comment_382922 Now that's pretty cool!In another lifetime, I ran a Scuba shop. In the early days all the Scuba tanks were made of steel. Some air filling stations still had small amounts of moisture in their air and over time the inside of the tanks would rust. Removing the rust used a device similar to yours. The difference was the tank laid on rollers and spun along the length axis. We used quartz rock chunks as the aggregate. Once the rust was removed, we could inspect the inside for pits in the metal that could weaken the steel causing a rupture when filling. Report
Just now1 min Author comment_382923 Thanks lew. It's amazing how clean it gets rusty parts ....... and... it didn't cost me a penny! Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.