October 29Oct 29 Popular Post comment_382273 Have a small "Panel saw" that had a few bends in the plate....like someone was in too big of a hurry to stop and sharpen the saw....and pushed a bit too hard...So, something to do with a hammer..to take out the bent areas....more of a tapping than a full-on Blacksmithing job...finally got it straight enough for a test drive..It will need a good sharpening done....but, it do cut fairly straight.....There is only enough room in thar, for 3 fingers....as the Index finger is supposed to ride along the side of the handle...pointing the way....C.E. Jennings Panels saw..10 pointer. Maybe I should polish the Brass, as well? Report
October 30Oct 30 Author comment_382298 For making cuts in Panels...where a full sized handsaw would be to LONG to fit. Report
October 30Oct 30 Author comment_382305 In use, today...Was rounding over a few edges..A few swipes is all it needed...Curved areas got this....Seymour Smith & Son Spokeshave.the block plane?Stanley Low angle, No. 60-1/2 Cordovan Block plane..Curved areas?I seemed to have a few...down around the foot/corners... Report
November 8Nov 8 Author comment_382575 C.E. Jennings saw..Has been straightened out, teeth have been sharpened up...Brass has been shined up...wood has been oiled up..It has a readable Etch showing up...Same piece of wood as the first test cut....rusty marks from the first cut...the rest of the cut took about the same amount of time as the first one...It is sitting over in the saw til, now...awaiting work. Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.