Does anyone know someone who can resharpen my 1/2" sawblades? Willing to pay for shipping and all of the fees. 

 

I usually have sawblade.com resharpen the blades for me but unfortunately, they only resharpen the blades that was ordered from them so as not to disrupt operations.

You can use a Dremel tool to do it yourself. I've sharpened mine several times. I use one of the fiber reinforced cutting discs and just give each tooth a quick touch on the cutting edge. It takes a while to get every tooth but it can be done. 

 

I've never had a problem with them cutting properly after sharpening. A LOT easier and cheaper than sending them off or replacing them!

 

I just leave the blade on the machine and rotate it around by hand. Make sure to mark where you start or you may never be heard from again.

Edited June 17, 20251 yr by Headhunter

I use a round cylindrical dremel bit on my blades . Look on YouTube and you will find both methods of sharpening. I usually only sharpen mine twice before replacing.

I don't know of anyone that sharpens them for hire, my guess is the cost would exceed the value of the blade. But as mentioned above there are a lot of folks doing it themselves.

I've heard of doing them with a Dremel, I've never tried it however.  I used to have a cordless Dremel that was my mom's, but I gave it to my ex when she moved out.  Handy little tool that I miss now and then, it would be perfect for this kind of task.