Ok super sleuths, I need a part for my ancient Delta 34-183 tenoning jig.  The tri ball handle that drives the clamp assembly has striped out at the set screw and it won’t stay tight.  This happened a couple of years ago and I red riled and tapped the hole on the other side.  The shaft hole is probably supposed to be 3/8” but is now .400.  I’ve tried McMaster Carr to no avail.  Any ideas before I spring for a new one?

Is this the one?

https://www.ebay.com/itm/305869980687?_skw=delta+ball+handle&itmmeta=01JF0NAZ4MR2NDN4DC1Z4563M2&hash=item473745840f:g:dtoAAOSwI45m-ULa&itmprp=enc%3AAQAJAAAA8HoV3kP08IDx%2BKZ9MfhVJKn%2FnnEH%2B5G1aUn7R2CyKpVXYT5vbSw0os%2BC4lVGPf7gOSMCliT9fJnLzS3nN%2B6Jhaz6fK2xK8U7475gZdvUsrBJf26fII4a1iP1cjqq0PfP5f8BJlLan%2FjdSTmKDFZUJp%2BtoEAJgZPEqKUIS8z5BJFqJ%2F%2B19HfX14xK0v8liKv3RvYslv%2BPrLNyxLiVBz5M6ksMLsEIGpgezqVad2r4j%2FwuVfA7f9ebMsxRuRMAoLP3s%2Bl2O6oF3oHbmFifyRj8Y6QU%2FKYgdmTwKWAfroyt8HQUozntAQFhF1H%2BBKrGYRnQgg%3D%3D|tkp%3ABk9SR8Dyq5X4ZA

Edited December 13, 20241 yr by Larry Buskirk

Sure is!  Well done Larry.  Not as shiny as mine but who cares.

11 minutes ago, Ron Dudelston said:

Sure is!  Well done Larry.  Not as shiny as mine but who cares.

Ron, there's a few of them listed on eBay. Some are chromed. Look for Delta BM4 handle.

I see that one sold, if you bought it tell Mark I sent you. 

Edited December 13, 20241 yr by Larry Buskirk

2 hours ago, Larry Buskirk said:

Ron, there's a few of them listed on eBay. Some are chromed. Look for Delta BM4 handle.

I see that one sold, if you bought it tell Mark I sent you. 

I did buy it and I will tell him that he owes you.

14 minutes ago, Ron Dudelston said:

I did buy it and I will tell him that he owes you.

 

Mark doesn't owe me anything, he's been a good parts supplier over the years.