Trying to clean up the mess...

And, barely making any progress...

The saw set is sitting out because..

I found this buried underneath a pile of scraps....was made BEFORE the big line up change at Disston in 1928...this is a D8 Panel saw..etch has the "8" inside of the "D"..

22" long..is marked as an 11 ppi...and it does have a small chip out of the handle..

Doesn't seem to hurt anything...had to clean this up, and give the saw plate a wipe down with 3in1 oil...then it was hung up on a hook above the bench...still feels fairly sharp, no missing teeth, either...

 

I still need my bench back, though...will try to build a couple boxes, out of the resawn scraps that were covering up this old saw...

If you keep looking, maybe Amelia Earhart is under there 😂

52 minutes ago, lew said:

If you keep looking, maybe Amelia Earhart is under there 😂

Or Jimmie Hoffa

 

57 minutes ago, steven newman said:

no missing teeth, either.

Better shape than me; five if you count my 4 wisdom teeth as if that wasn't obvious.

Maybe he will find that screw I lost. 

I'm sure most of it just followed him home.  Danl

Also found..and repaired..

Drill bit was broken...rusted up....had to find a replacement drill bit, disassemble everything to clean off the rust....and free up the plunger.  DW40 to get things moving again..

 

Cleaned up the work area #2..

Router Table was sent back to it's "parking spot"..

Tablesaw was set up for resaw work..

And most of the "good" leftovers were resawn to 1/2" thick..

Stay tuned...