A while back I made this door plaque that consisted of one American flag but I wanted to carry it further so I reversed the pattern and made a second flag with the idea of placing a profile of an eagle head above  a shield between the flags with a "WELCOME" banner below the flags. I have looked at a huge amount of eagle patterns but haven't been able to find one that fits the bill. I'm hoping to get Corel Draw 5 to modify a pattern but am not able to at this time. Do any of you have or know where I might find the eagle head pattern and a banner pattern that possibly replicates the waving of the flags in the banner? The dimension of the flags together is 28" X 12" and I will be mounting the plaque on a backer board and then attached to our front door. Thanks for any assistance you folks may be able to lend!

Mike, here's a couple places to check, they all have yard art type patterns and might have something you can use or adapt.

http://www.meiselwoodhobby.com/Home.aspx

http://www.cherrytreetoys.com/

http://www.thewinfieldcollection.com/

---

Greg
Scroll Saw forum host

http://www.thesawdustfactory.net/

Mike

Here is a picture of the banners I though about when I read your post. I think it would would look nice and work well with the design. Shouldn't be too hard to draw out and cut, and would give you room for the welcome message.

---

Wayne Mahler
God bless and protect our troops that serve so we can be free.

Greg thanks for the links I'll check them out a bit latter. Wayne thanks for the banners. The top one is exactly what I had in mind and I'll use it with your permission as a guide and draw up some samples in a few days. Thanks again you guys are great!

Mike

Those came from another web site of photos. I have used pictures like this to design what I needed, Sort of like a base idea to go from. I did look to see if I still had the plans of the one I made, I can not find them or I would post them for you.

---

Wayne Mahler
God bless and protect our troops that serve so we can be free.