Search the Community
Showing results for tags 'rough sawn'.
Found 2 results
-
Got to start somewhere. Breaking down a couple of 4/4 x6 x8' Walnut planks. Cut a few down to match the raised panels I made a while back. Cleaned up the rough sawn edges a bit, and marked them for a rip cut. After a rip down the middle, these will go on the ends, to house them raised panels. Going to get these to a somewhat finished sized, and then smooth the faces up. Less to plane, that way. Tried to handsaw these boards down, ran out of breath ( COPD??) so an OLD Sears Craftsman Circular saw was used. It will also do all the rip cuts. Corner posts were straight edged up. Then set up for a rip down the middle. I'll then add a Tongue & groove joint to the edges of the corner posts.
-
My wife has been wanting a basket for a while. I made this one yesterday. Now she wants a larger one.
