Search the Community
Showing results for tags 'problem'.
-
Good morning fellow woodworkers, I have a delta tablesaw problem I need to fix and have received no feedback from Delta on the e-mail I sent them regarding my problem so I thought maybe you could help. I purchased a Delta model unisaw with a 10" dia. blade, 3 1/4 HP motor, 52" table, and a Biesemeyer fence system in 2005, model 36-812 with serial number 05A 95089 type 2. An unusual noise is produced sometimes as the blade is spinning down from use. This noise was produced since I purchased the saw, but I could never find the source of the noise, unti
-
I've had a Rigid drum/belt sander for a year now and it does a really good job sanding. However, even with a high volume vacuum, it still does a poor job collecting dust. I tried building a cardboard enclosure and I'd cut and reshape as I went. I have had limited success. Without enclosing the whole thing, have you or anyone you know came up with a better way of dust suppression on this tool?
-
I have asked this question before but I still have no solution. My problem is getting rid of pencil marks left on the boards. I even have a pencil to get rid of unwanted pencil marks. Water is supposed to dissolve the marks.
-
I have a craftsman 10 inch compound miter saw (model MODEL NO. 137.212360 SN#041300896). A few weeks back i noticed that when adjusting the angle of the blade it was becoming increasing hard to turn the blade assembly whether it be to 45 degrees right or left. today I got motivated and disassembled the (part X3RS - TABLE) from the (part X3SS - BASE). There is a (part X3SQ - SLIDE PLATE) between the two. I noticed that it looks like the saw has been 'rubbing' one side of the slide plate to the point where it has made a groove in the metal. The table now falls into this groove and is what is mak
-
John, I've been getting this since last evening.