© very old picture. I doubt it ever got copy righted.
Credit I give credit to my cheap little printer for enlarging the small picture in to the size I used to carve.
IMG_20220805_153524032 friday aug 5 finished with this project
By Smallpatch
- 186 views
- View Smallpatch's images
11 x 19" out of maple wood. Only power tool were used. An air brush was used to apply the color. dye stain and water base colors both was used.
First time I ever carved a dragon and I did want a friendly type so I was being careful with the color I chose!
When I sawed out the outside I was sawing through 1 3/4 maple and plywood so I used Olson #5 blades then I removed the backer board before I started sawing out the interior pieces and only had the 1 inch maple to saw in to 31 pieces and I used mostly flying dutchman# 3 and some #5's. Its very important to saw the pieces so they will slide together both directions when its time to apply the glue then put the screws in and if I don't pre drill the holes ahead of time lots of busted wood will have to be glued up before I can continue assembling this picture.
Credit
I give credit to my cheap little printer for enlarging the small picture in to the size I used to carve.
Copyright
© very old picture. I doubt it ever got copy righted.
- lew and FrederickH
-
2
Photo Information
- Taken with motorola Moto E (4) Plus
- Focal Length 3.6 mm
- Exposure Time 1/30
- f Aperture f/2.0
- ISO Speed 64
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.