Jump to content

Pine Table: Progress report #3

Rate this topic


Recommended Posts

Most of the glue ups are now done

ning-imag0101-1643-90.jpg?width=750

This mess will exit the clamps tomorrow, after a trip to the Doctor's office.

 

Made some use out of the NEW Scrollsaw. I was a bit too tired to hand cut the corner blocks, so the scrollsaw did the dirty work. Was a bit hard to cut a straightline in 5/8" thick Poplar, but I got it close enough

ning-imag0102-1643-62.jpg?width=750

yeah, four of them.Two screws and a bit of glue. I'll come back later, and add a slot to attach the top with. Laid one piece of pine down to get a measurement for the bottom shelf

ning-imag0103-1643-92.jpg?width=750

Still have to cut and clean up the other half.Then add them to the bottom cleats/stretchers. Maybe then, I can start to work over that Pine top.Stay tuned for further updates...

 

Link to post
Share on other sites
  • 1 year later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...