Jump to content

Recommended Posts

2 hours ago, Gerald said:

I looked to see what this stuff costs and I also did not see the plate. I have one ball mount I also could not find on  site. It has a shaft apparently for mounting , with a slight grove and a screw in the middle of that. The shaft is slightly pover 1 inch and has a hole in it slightly smaller than the hole in the ball mounts.

At the site these links to the left show many more pieces.

 

Capture.PNG.df63acc001922fadc0eea382e1979a3b.PNG

Link to comment
Share on other sites

21 hours ago, Gerald said:

I also kinda wondered about the way that plate overhangs and why is there hat flat on one side.

Capture.PNG.04df8b6e4b3f9866b9f64dbc9b9f063e.PNG

 

I got the above picture from an old catalog I found.  They didn't have as many choices as they have now.  It also shows the square plate.  I would bet the mounts with the three tabs would fit the plate nicely.

 

I found the catalog at Vintage Machinery.

http://www.vintagemachinery.org/pubs/detail.aspx?id=23373

 

Capture.PNG.ac5026e0ea86f8a0da7dd25d6cffc44f.PNG

 

Here's the catalog pdf link.

http://www.vintagemachinery.org/pubs/11562/23373.pdf

 

 

 

 

 

Link to comment
Share on other sites

5 hours ago, HandyDan said:

Capture.PNG.04df8b6e4b3f9866b9f64dbc9b9f063e.PNG

 

I got the above picture from an old catalog I found.  They didn't have as many choices as they have now.  It also shows the square plate.  I would bet the mounts with the three tabs would fit the plate nicely.

 

I found the catalog at Vintage Machinery.

http://www.vintagemachinery.org/pubs/detail.aspx?id=23373

 

Capture.PNG.ac5026e0ea86f8a0da7dd25d6cffc44f.PNG

 

Here's the catalog pdf link.

http://www.vintagemachinery.org/pubs/11562/23373.pdf

 

 

 

 

 

Thanks Dan , the piece I could not find is called a up down converter. Problem now is need a 1 1/8 id tube and a clamp to use it. Might be able to build something in wood to hold it in bench vise.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...