Jump to content
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble
DAB

Salt and Pepper mill holders

Rate this topic

Topic Summary

Created

Last Reply

Replies

Views

DAB -
Grandpadave52 -
15
178

Top Posters


Recommended Posts

Problem solving at it's best

Steve

Share this post


Link to post
Share on other sites

Great solution and end products...

Don't forget the ammo next trip to town.;)

Share this post


Link to post
Share on other sites
24 minutes ago, DAB said:

a nice man brings it to me, a case at a time.

 

better than a milkman, plus you don't have to set out the empty bottles 'er casings.:P

Share this post


Link to post
Share on other sites

Very well done sir!

Share this post


Link to post
Share on other sites
3 hours ago, Jim from Easy Wood Tools said:

Very well done sir!

small confession:  it was done with both non-carbide parting tool and a carbide set of tools from that blue tool place..... :)

Share this post


Link to post
Share on other sites
31 minutes ago, DAB said:

small confession:  it was done with both non-carbide parting tool and a carbide set of tools from that blue tool place..... :)

No confession needed!  This is not the EWT forum....  nor is it the carbide turning forum.....  You did a great job sir, no matter what tools you used.

Share this post


Link to post
Share on other sites
4 hours ago, Jim from Easy Wood Tools said:

No confession needed!  This is not the EWT forum....  nor is it the carbide turning forum.....  You did a great job sir, no matter what tools you used.

just made this today.  will be donated to a fund raiser for a local family who had their house burn to the ground, losing all their material goods.  and sadly, no insurance.

 

4 layers of cherry, mineral oil/beeswax finish.  7-1/2" outside diameter, 3-1/4" high, 6" inside diameter, 2" deep.

 

cherry cuts great with sharp tools.  which reminds me, i think i need some new carbide inserts for some of my tools.

IMG_3690.jpg

Share this post


Link to post
Share on other sites

Some purty grain in that DAB.

Blessings for contributing to the fundraiser...I'm sure it will be greatly appreciated.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...