Cliff Posted August 6, 2015 Report Share Posted August 6, 2015 (edited) A while back I bought a couple of these http://www.craftsman.com/craftsman-12-in-bar-clamp/p-00931482000P And posted that I rather liked them. I still do, but they are not 12" I was doing a glue up of some drawer boxes and wanted to use the clamps to put the squeeze on the Box Joints. They didn't fit. I measured the box measured the clamp it was a mis match But I observed a limiting factor. The factory drove a plastic stop in the bar. The intent is to prevent one from letting the head slip off the end and at the same time serve as a mounting location stop to flip the little clamp end around for spreading. So I drove them out and go a couple more inches out of the b clamps. It was great, I was a genius, Right up to that point where I slipped the head off the end. Oh man getting all the kings horses back together. Ya gotta use a chisel to cut the bond of the orange rubber grip off to get to a screw. They assembled it with screws but hid one under there. Then when I took the clamshell apart to see about getting the head back on SPROINGGGGggGGGgGGG Yah springs went flying. Oh man. I think I may have actually said something harsh like Gosh Durn DagNabbit and other colorful verbiage It was a hour figuring out (a) if I had all the springs and (b) how to reassemble it. this is what the little plastic bit looks like http://i1002.photobucket.com/albums/af143/zydaco/Show and Tell/Plastic bit_zpsuycvacqv.jpg This is what I did to keep the head on and get the extra inches. http://i1002.photobucket.com/albums/af143/zydaco/Show and Tell/Allen screw _zps4gei4ul5.jpg Edited November 25, 2017 by Ron Dudelston tags added John Moody 1 Quote Link to comment Share on other sites More sharing options...
lew Posted August 6, 2015 Report Share Posted August 6, 2015 Garsh Darnnit, I hate it when that happens. Ernie Richardson (BAA Bugler) 1 Quote Link to comment Share on other sites More sharing options...
Courtland Posted August 22, 2015 Report Share Posted August 22, 2015 (edited) I've had similar cases happen Cliff, and yep, what a PITA. I also love their advertising, hey 12" should be 12"! Not 11 and 5/8th! Hey, at least you did not do what I am known for, I would have had spread the glue, ready to clamp, then checked to see if the clamps were going to fit! Edited August 22, 2015 by Courtland added more text Ernie Richardson (BAA Bugler) and John Moody 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.