Search the Community
Showing results for tags 'tabs'.
Found 1 result
It seems each time I design a project, I wind up switching cutters for the final cutout of the design. My question is if I use tabs (minimum of four, do you think the project will remain still if I run the cutout file along with other files that use the same cutter. An example might be like the one pictured. The material is 5x12x1/2 inch thick. Router bits used include a 1/8th spiral cutter that cuts the groove, and clears out the waste in the name, and does the final cutout of the design. Then there is a 60 deg flat tip that does the work on the text to clean it up and carve the year. I guess I could answer my own question if I just go for it on a piece of scrap, huh? It sure would help cut down on bit changes since I am the bit changer!