Search the Community
Showing results for tags 'remodel.'.
Found 1 result
Other thread was getting longwinded. Decided to carry on in a new one. Floor no longer had a creek running through the shop...went down and cleaned "house" The other day, I couldn't even tell where this benchtop was. . Brass wheel was removed from the grinder, as was the old, worn out wire wheel on the other side. Bought a new 1" fine wheel. Installed that. Sanding center was getting in my way a lot...decided to switch the two around.. Air compressor can stay there. Or, even slide further under the bench. bench is just an old tabletop ( no legs) sitting on a pair of sawhorses. "plan" was to slide the drill press as far to the left as I could...without getting in each other's way... Had to re-route the power cords ( need a couple wire ties, too) And, IF I need the vise.. Table is easy to remove, and stashed out of the way. Drill til? Needed a topper to it. Hauled that fancy 1 x 10 to the shop. Crosscut and ripped to size....needed pilot holes.. Then a countersink was used.. Why change bits, when I can just change drill and all....installed the top on the til..then moved the entire mess to it's new home.. Another view? Still a lot of storage space, both in front.. Might be another couple boxes headed this way....and, since there IS a flat shelf on top.. Couple of spokeshaves, most of my squares, and a marking gauge...have to work on this area a bit more. There was one brace drill that was too big for this til.. The 14" Stanley is now "hanging" with the Eggbeaters.... Still have quite a bit of pine left over.. So, I'll see what I can cobble up out of this..stay tuned..