Jump to content
  • entries
    4
  • comments
    15
  • views
    2,592

About this blog

Seems my sister is at it again! Recently received an email from her Pastor about a request to make a "Communion Table" for their church.

Entries in this blog

Finishing Up The Top

With the base finished, all that was left to do was trim out the top with the walnut edge trim. Glue, clamps and some pin nails.   I forgot to take photos of the top to apron mounting system but this Sketchup drawing should explain what I did. These are simple wooden clips with their tabs captured in slots that run around the perimeter of the inside of the aprons. The slot is 1/4" wide by 3/8" deep. The clips are cut from 3/4" thick maple and the tabs sized of a snug fit in the slots.

lew

lew

Mistakes, Mistakes, Mistakes!

Once the legs were completed, I started on the aprons and stretchers. The stretchers are to be mortised and tenoned into the legs. The long stretcher needed to be securely fastened into the side stretcher but their thickness was only 3/4 ". That meant a very short tenon (1/2") on the ends of the long stretcher. I decided, mistakenly, to use a fox tenon and a dovetail style mortise, with tapered sides and wider at the bottom.     It took a little work to get the mortises chop

lew

lew

The Original Request

My sister's Pastor asked if I could make a communion table for their church. In the past, I've made a lectern/pulpit and a kitchen work table. This seemed like it should be an uncomplicated build.   The pastor supplied me with his original thoughts and an image-   He picked this particular image for it's size/proportions, however, the "arts and craft" style was not his first choice. That style didn't really fit with their church's other furnishings. He said he didn't re

lew

lew

Trim and Legs

For such a simple table, this thing has run me through the funnies big time. Everything started out pretty good. The walnut trim, for the top, was made by multiple passes over several different router bits to get the desired profile.       It'll take a little sanding to smooth things out but I am happy with the results.   Next I turned to the legs. I milled down some 1 3/4" maple into 1 3/8" square blanks. Then laid out the locations of all of

lew

lew

×
×
  • Create New...